Low Temperature Automation Electric Multi Turn Valve Actuator

Low Temperature Automation Electric Multi Turn Valve Actuator

Low Temperature Automation Electric Multi Turn Valve Actuator is widely applied in petroleum, chemical, water treatment, shipping, paper making, power plants, heating, building automation and other industries.Double sealed structure of the wiring chamber. The internal electrical devices are guaranteed to be in a perfectly sealed protection when the actuator is performing on-site installation and debugging. Low Temperature Automation Electric Multi Turn Valve Actuator provide the most reliable solution to satisfy our valuable customers and exceed expectations. AOX has its ownfactoryinChina.AOX will continue to develop more advanced products integrating high technology and be ready the most reliable solution.

Low Temperature Automation Electric Multi Turn Valve Actuator Introduction

Low Temperature Automation Electric Multi Turn Valve Actuators are designed for all multi-turn valve applications (linear motion valves) such as globe valves, gate valves, etc. Low Temperature Automation Electric Multi Turn Valve Actuator will go through a strict temperature test before leaving thefactory. Our Low

temperature automation electric multi turn valve actuator can be customized according to customer's special requirements. AOX is asupplierto many large enterprises.Based on a wide range of products including high performance multi-turn, part-turn and linear actuators, we offer automation solutions for all valve types from ball valves to dampers.

Low Temperature Automation Electric Multi Turn Valve Actuator Parameter (Specification)

Low Temperature Automation Electric Multi Turn Valve Actuator Feature And Application

Torque Range: 40 - 1000 Nm Direct Output

Ambient Temperature: -30°C --+70°C  Optional: -40°C- 60°C

Anti-vibration Level: JB/T8219

Noise Level: Less than 75 dB within 1 m

Corrosion level: Epoxy powder coating NEMA 4X corrosion protection is optional.

Applicable Voltage:3 phase: AC 380 V (±10 %) /50/60 Hz (±5 %)

optional: 1 phase AC 220 V

On/off type signal:

Input : AC 110/220 Input

Signal Feedback: Integrated fault contacts,Close the valve contact,Open the valve contact

Motor overheat protection

Moisture-resistant heaters (anti-moisture device)

Reliable electronic system

Phase sequence self-correction

Motor overheat protection

Limit and torque sensing

Two-wire control protection

Three-phase power phase sequence protection

Remote control settings

Self-diagnosis fault alarm

Low Temperature Automation Electric Multi Turn Valve Actuator details

1.Motor protection for Low Temperature Automation Electric Multi Turn Valve Actuator.

In order to protect the motor against overheating, there are two series of thermal switch installed in the three-phase motor or single-phase motor winding inside. They are involved in the control circuit to prevent damage to the motor because of winding overheating.

2.Diferent control options meet your specific requirement.

Low Temperature Automation Electric Multi Turn Valve Actuator can be combined with various controls from simple On/off and intelligent modulating control or fieldbus interface.

3. Integrated Local control for Low Temperature Automation Electric Multi Turn Valve Actuator

Local control switches and locking type selector switch local/stop/remote are magnetic switches, controlled by magnetic reed, thus assure the damp proof sealing inside of the actuator.